=======================
Configuring the Station
=======================

When you first launch the gui you should get the following screen.
You will first need to specify a Station Configuration file in the highlighted tab:

.. image:: gui_screenshots/station_config_1.png

First select the highlighted browse button and navigate to the correct station configuration YAML file:

.. image:: gui_screenshots/station_config_2.png

If this needs editing select the highlighted edit button, and you will be able to edit the file using gedit:

.. image:: gui_screenshots/station_config_3.png

For instructions on how to edit please see the :doc:`../station_config` page

.. image:: gui_screenshots/station_config_4.png

After your station configuration YAML file is ready click the highlighted load button:
You should then see the following populated screen:

.. image:: gui_screenshots/station_config_5.png

**NOTE:** If you have just made changes please ensure you can see them on the screen.
If you can't, try and load the config file again. If you still can't load, close and reopen the GUI and try again.

If you are using a :doc:`../cabinet_config`,
you can select the station the screen shows using the dropdown box shown below.

.. image:: gui_screenshots/station_config_6.png